C*Pix SDC2000 Manual de instrucciones descargar pdf (Pagina 103)

Ignite SDC/HDC Robotic Camera Instruction Manual 103

Adjustments

Camera adjustments can be accomplished in one of two modes, shooting

mode or menu mode.

Shooting mode adjustments are accomplished by pressing rear panel

switches while viewing a specific target object/scene.

Menu mode adjustments are accomplished by accessing the USER menu,

navigating to a desired submenu, then adjusting the value of a specific

submenu item.

Shooting Mode Adjustments

White Balance Adjustment

Set the automatic white balance control by pressing the ENTER/AWB

switch (with no menu displayed), while shooting a white object that fills at

least 50% of the screen.

Note If the white signal level is over 100% or less than 50%, the white balance may

not adjust properly.

Black Balance Adjustment

Note Black balance is adjusted with the lens closed. When the motor drive lens is

controlled from the camera, adjusting the black balance causes the lens to

automatically close.

Set the automatic black balance by pressing the UP/ABB switch, with no

menu displayed.

Gen-lock Adjustment

When multiple cameras are used or the camera is combined with other

equipment, it is necessary to adjust the phase-for-phase matching by

external synchronization.

Using a two-phenomenon oscilloscope, observe the external synchronizing

signal input (black burst signal) and video signal output waveforms.

Adjust the horizontal phase using the camera GEN-LOCK menu.

When using HD synchronizing signals:

1. Roughly adjust the synchronizing signal input and video signal output

phases by H PHASE-COARSE.

1 2 ... 98 99 100 101 102 103 104 105 106 107 108 ... 121 122

Sin comentarios

C*Pix SDC2000 Manual de instrucciones Pagina 103