C*Pix SDC2000 Manual de instrucciones descargar pdf (Pagina 33)

Ignite SDC/HDC Robotic Camera Instruction Manual 33

Section 3

Operation

Operating Procedure

1. Turn on all equipment power.

WARNING Ensure personnel and obstacles are clear of the camera during power-up.

The robotic head will automatically rotate to the preset zero degree pan

and tilt location.

Note The camera robotics may make some noise for the first few hours of opera-

tion. This is due to a special type of grease that will seat into the gears to

provide long life lubrication of the mechanical components. The noise should

abate soon after the camera is put into operation.

2. Adjust the camera.

Use the SHOT Director to adjust the camera.

Refer to the JSC-2300 SHOT Director Robotics/Camera Controller

Instruction Manual for procedures and Appendix A-SD (NTSC) Camera

Block, Appendix B-SD (PAL) Camera Block, or Appendix C-HD Camera

Block for adjustment options.

You should adjust the following items the first time the camera is used.

a. Camera ID and IP address.

The pan/tilt head and JSC-2300 SHOT Director are factory set to

default IP addresses to allow the units to communicate initially. If

you are connecting multiple cameras, you will need to set each

camera to a unique ID and IP address using the JSC-2300 SHOT

Director. Refer to Appendix D-Robotic (Pan/Tilt Head) for default and

recommended IP addresses and camera IDs.

b. White balance adjustment.

This adjustment is needed when the camera is used for the first

time, after leaving it unused for a long time, or when the lighting

condition or brightness change.

Note After adjusting the white balance, re-adjustment is not needed under the

same conditions.

1 2 ... 28 29 30 31 32 33 34 35 36 37 38 ... 121 122

Sin comentarios

C*Pix SDC2000 Manual de instrucciones Pagina 33