C*Pix SDC2000 Manual de instrucciones descargar pdf (Pagina 29)

Ignite SDC/HDC Robotic Camera Instruction Manual 29

Installation Procedures

Prompter (Optional)

1. Slide extrusion slots onto mounting plate rods and rotate rods to

tighten (Figure 10). Mounting plate rods slide into the back of the

extrusion where two slots provide alternative vertical positions for the

prompter. The rods attach to the extrusion using a T-bolt that is

tightened by turning the rod.

Figure 10. Extrusion

2. Rotate the drop plates to the orientation shown in Figure 11.

Figure 11. Drop Plates

3. Attach drop plates to extrusion and tighten red fixing screws. A choice

of mounting holes are provided to raise and lower the monitor in

relation to the hood to prevent the outer edge of the TFT screen from

appearing in the shot.

4. Attach the hood to the extrusion and rotate hood columns to tighten.

5. Move prompter unit back on the support rods until the lens is nearly

touching the glass and lock in position with small locking levers.

6. Slide the whole prompter assembly back on the mounting plate rods to

obtain best possible balance of the pan/tilt L-bracket. Attach

counterweights if necessary.

92_09_r0

92_10_r0

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 121 122

Sin comentarios

C*Pix SDC2000 Manual de instrucciones Pagina 29