
SDC 2002
4.11 Monitoring Menu
4-205
Operating Instructions - Rev. 1 / 6.2003
2. Sequence
Setting
Defines the sequence of the displayed RGB signals.
Click on the key to select one of the possible settings: RGB or GBR.
The standard setting is RGB and normally there is no reason to change it.
3. H-Blanking
Switches the horizontal blanking of the monitoring signals on or off.
Click on the key to select one of the possible settings.
4. Display Mode
Defines the sequence of the displayed RGB signals.
Click on the key to select one of the possible settings: RGB or GBR.
The standard setting is RGB and normally there is no reason to change it.
5. Clamp Signal
Setup
Switches the clamping of the monitoring signals ANALOG OUT RGB (rear
of Rack 2) on or off.
Click on the key to select one of the possible settings.
Comentarios a estos manuales